Mobile Bouncy Castle Repairs

Bouncy Castle Repairs

We don’t just PIPA test Bouncy Castles, we also repair them with our custom-made Twin Needle Sewing machine, which is ideal for  Mobile repairs on site.

We have been repairing bouncy castles for 15+ Years and have seen and repaired some very tricky inflatables.

We offer a mobile bouncy castle repair solution, so if you are a bouncy castle company, a Leisure Centre, or a play park that needs a repair, then please get in contact with us.

With all repairs, it is better to save a stitch now, as in the long run it will save nine, so the old saying goes, so keep a close eye on all your seams for signs of stretching or hole elongation on high wear areas.

Please see our pricing page for all details. Thanks

Pictures of Bouncy Castles and Inflatables we have Repaired

Ripped roof on a bouncy castle
replaced roof on a bouncy castle

Ripped rain cover on a large bouncy castle, removed and replaced with a new Blue cover

A bouncy castle that is in need of a repair, the bed tie has ripped
Large bouncy castle bed tie repaired by us here onsite

Here you can see a common problem: the bed tie has ripped its full length, causing a large bump in the bouncing bed. Caution should be used, as this can get worse fast, causing a major failure and accident if it is not fixed before use

Mesh window repair
Mesh window replacement on a bouncy castle

These mesh windows were maliciously cut out and caused a user containment issue, so they needed to be replaced as soon as possible. All completed onsite

Before the new step repair to a slide combo bouncy castle
New step for a bounce and slide Bouncy Castle Repairs

Here you can see a common problem with older units, the step has ripped off the slide sheet, so a new step has been made and fitted. The customer had lost the foam so even the foam inside the step was replaced.

bed seam before repair
Bed seam repair on a bouncy castle

The Webbing on this unit had completely failed and needed to be replaced along its entire length, the webbing was removed and the seams were sewn up.

roof before repairing on a bouncy castle
Roof repair on a bouncy castle

The netting on the slide roof had failed under normal use and needed to be replaced, the decision was made to replace it with PVC as it is stronger and should last longer in the long run

hole in the side of a bouncy castle
after hole repaired in sidewall of a bouncy castle

The bouncy castle joint was damaged when the unit was being packed away, the operator was using this part to pull it over. It was a flat seam but due to its location, it was turned into an internal seam as it was stronger.

Netting needs repair on a bouncy castle
netting fixed on a bouncy castle

The Netting was damaged and needed sewing back into this bouncy boxing ring. Not too difficult but gets harder with netting so it stays straight when repairing and inflated afterward. Some Large needed inflatables like boxing rings can be a challenge

Bouncy castle repairs before bungee run velcro
Bouncy castle repairs after bungee run velcro

The soft Velcro had worn away with many years of use on this bungee run, easy enough to replace just a lot of un-picking of stitched to repair it properly

before the surf sim repair
Surf sim bed repair

Surf sim bed tie repair, is an easy and very common repair, the material used inside had afraid and was not folded over to stop it from running and ending up like this. Most bed tie problems are either like this or the material rips

Hole in bouncy castle repair
Hole in bouncy castle repaired

Bed seam joint thread failure is very common and a good reason to buy twin-stitched castles. if the first row goes you have a little time to get it repaired but with single stitch once its gone its a hole and should not be used.